Saturday, February 14, 2015

PHILIPS BDP7100/12 FIRMWARE UPDATE AND POWER SUPPLY CIRCUIT

PHILIPS BDP7100/12

FIRMWARE UPDATE AND POWER SUPPLY CIRCUIT 

Firmware Upgrading
Note: Upgrading the firmware will restore all the user settings to default.
Preparation to upgrade firmware
1. Download the software update from ww.philips.com
2. Unzip the zip-archive file
3. Start the CD Burning software and create a new CD project (data disc) with the following settings: Character set: ISO9660, Joliet
Format: Mode 1
Recording mode: NO MULTISESSION,
SINGLE SESSION (TRACK-AT-ONCE),
FINALIZED CD (CD Close)
Recommended applications: Neo Burning, Easy CD Creator
4. Place the content of the zip-archive into the root directory of the new CD project.
5. Burn the data onto a blank CD-R or CD-RW
Procedures to apply the Firmware Upgrade
1. Power up the set, eject the tray , insert upgarde CD and close the tray.
2. The set will identify the CD. The set will display: “LOAD”
And, on the TV screen, it will show:
“Verifying Firmware Version”
3. After about 10 minutes, ejecting the disc, the set will display: “OPEN”
And, on the TV screen, it will show:
“Firmware Update
Do you want to update Firmware?
(Please remove a disc from the tray.)
>Current Version: 070913.02_12
>New Version: 070925.01_12 “
4. Remove the upgrade disc and select ‘Yes’ to continue.While updating the firmware, on the TV screen it will show:
“Firmware Update
Now, Processing..
Please, do not turn off the power”
And the set will display:
“CD-UP”
Note: It may take about 5 to 10 minutes to complete the upgrading process. Do not press any buttons or interrupt the mains supply
during the upgrading process, otherwise the set may become defective.
5. When the upgrade process is completed, the set will go to standby with the tray door remain open.
How to read out the firmware version to confirm set has been upgraded
1. Power up the set and open the disc tray.
2. With the disc tray remain open, press INFO key on RC for 10 seconds.
3. The firmware version dialog will appear as shwon below:
“LDR:0709 / Front: 015
S/W: 0700925.01_12
Region: B/02 (BD/DVD)
Macrovision: BSS02”
Note: The same procedure is applicable also for upgrading servo (loader) Firmware except the Screen Display may be different.
Procedure to reset the settings to initial mode
1. Power up the set without any disc inserted.
2. When the set displays: “HOME MENU”, press and hold the skip forward key on the Front Panel of the se
3. The initial mode will be activated and the set will display: “NO DISC”
4. On the TV Screen, it will show the language selection menu as shown in figure 2 and select the Language by pressing the corresponding key as described in the menu.
Note: Resetting the initial mode will restore all the user settings to Default.

SMPS POWER SUPPLY CIRCUIT 

CLICK ON THE IMAGE TO ZOOM IN