Monday, September 14, 2015

SONY KDL-26E4000 - KDL-32E4000 - KDL-40E4000 BLINKING CODES AND SERVICE MODE

SONY KDL-26E4000 - KDL-32E4000 - KDL-40E4000 

BLINKING CODES AND SERVICE MODE 

LED BLINKING AND ITS CAUSES 
Number of LED Flashes
Error Description
Action
02
DC_DET (12V main voltage).
Goes into standby and LED flashes.
06
Panel Det error.
Goes into standby and LED flashes.
07
Internal temperature error.
Goes into standby and LED flashes.
08
Audio error (SP protection).
Goes into standby and LED flashes.
10
Digital error.
Adds error to error menu.
11
NVM error.
Adds error to error menu.
12
I2C error VCT.
Adds error to error menu.
13
Balancer error.
Goes into standby and LED flashes.
14
HDMI error.
Adds error to error menu.
15
Tuner Error
Adds error to error menu.
16
I2C CH1 (VERD TAS).
LED error.
17
I2C CH0 (VERD NVM/RTC).
LED error.
18
Digital demod.
Adds error to error menu.
19
USB error
Adds error to error menu.
20
CI error
Adds error to error menu.
21
VCT error
LED error.
22
MSP error.
Adds error to error menu.

How to enter the Service Mode
Service adjustments to this model can be performed using the
supplied Remote Commander RM-ED011W.
ON SCREEN DISPLAY > DIGIT 5 > VOLUME + > TV POWER ON
1. Turn on the power to the TV set and enter into the stand-by mode.
2. Press the following sequence of buttons on the Remote Commander.
3. The menu will appears on the screen.
4. Move to the corresponding adjustment item using the ‘UP ’ or ‘ DOWN’ arrow buttons on the Remote Commander.
5. Press the ‘RIGHT ’ arrow button to enter into the required menu item.
6. Adjust the data value using the ‘ UP’ or ‘ DOWN’ arrow buttons on on the Remote Commander.
7. To go back at any time press the ‘Return’ button on the Remote Commander.
8. Press the ‘Menu’ button on the Remote Commander to quit the Service Mode when all adjustments have been completed.
Note :
# To place the Remote Commander in ‘Service Mode’ press the following buttons together for two seconds.
ON SCREEN DISPLAY > DIGIT 5 > VOLUME +
# To use the Remote Commander in ‘Service Mode’ press the rewind button on the Remote Commander twice.
To take the Remote Commander out of ‘Service Mode’ press the same buttons above together again for two seconds or remove thebatteries from the Remote Commander.
# After carrying out the service adjustments, to prevent the customer accessing the ‘Service Menu’ switch the TV set OFF and then ON again.