Monday, May 30, 2016

Asus ZenFone 2 – Disassembling procedure – How to remove the case – How to remove the vibrator motor – How to remove the antenna – mobiles and smartphone Repair and service

Category: Mobiles and Smartphones repair and Service 

Contents of this article 

  • How to remove the case 
  • How to remove the vibrator motor
  • How to remove the antenna 

Asus ZenFone 2

DISASSEMBLING PROCEDURE 
Use your fingernail to gently pry off the phone's back cover at the indicated location. While
your fingernail is under the back cover slide your finger around the edges of the phone until the cover pops off.

Remove the thirteen black screws and the single silver screw from the back of the phone with a JIS size 00 screwdriver.
The black screws are 2.8 mm in length
The silver screw is 5.5 mm in length
The black screw located next to the camera and the flash is covered by a sticker. This screw can be easily removed as if there were no sticker on top of it, the point of the
screwdriver should be able to pierce through the sticker easily
Use a plastic opening tool (or the prying tool of your choice) to remove the inner phone backing.
The parts of the inner backing held down by two strips of double sided tape can be easily loosened by inserting the plastic opening tool underneath it and gently lifting it up.
Take the speaker out of the back of the phone. It should come out easily as soon as the inner back is removed because nothing is holding it down in place anymore.
Vibration Motor
Use a plastic opening tool to remove the vibration motor.
Use a plastic opening tool to unplug the vibration motor at the indicated location.
Take the speaker out of the back of the phone. It should come out easily as soon as the inner back is removed because nothing is holding it down in place anymore.
Antenna
Use a plastic opening tool to gently pry up both ends of the antenna. The antenna connections can be easily bent out of shape. Be sure to lift from underneath the cable as shown.