Saturday, May 21, 2016

Epson EH-TW9200 – EH-TW8200 – How to clean the air filter – How to replace the lamp – How to reset the lap hour


Cleaning the air filter
a. Press the POWER button on the remote control or the control panel to turn off the power, and then disconnect the power cord.
b. Remove the air filter cover. Hook your finger into the tab on the air filter cover, and remove it from the lens side.
C. Remove the air filter. Grip the knob in the center of the air filter and pull it out at an angle.
d. Hold the air filter facing down and tap with the surface it 4 or 5 times to remove the dust. Turn it over and tap the other side in the same way.
e. Remove any dust remaining on the air filter by using a vacuum cleaner from the front side.
F. Install the air filter. Grip the air filter by the knob in the center and insert it at an angle.
G. Install the air filter cover. Secure the tab on the outside first, and then secure the tab on the lens side.
Lamp replacement period
# The lamp replacement message is se and quality of the projected images. The message display time t to appear after 3900 H in order to changes depending on the usage maintain the initial brightness situation, such as the color mode setting and so on.
# If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases. When the lamp replacement message appears, replace the lamp with a new one as soon as possible, even if it is still working.
# Depending on the characteristics of the lamp and the way it has been used, the lamp may become darker or stop working before the lamp warning message appears. You should always have a spare lamp unit ready in case it is needed.
Replacing the lamp
a. Press the POWER control or the control panel to turn off button on the remote the power, and then disconnect the power cord.
b.Loosen the lamp cover fixing screw.
c. Remove the lamp cover. Slide the lamp cover straight forward and remove it.
d. Loosen the two lamp fixing screws.
e. Remove the old lamp. Grip the knob firmly and pull it straight out.
Resetting lamp hours
After replacing the lamp, make sure you reset the lamp hours.
The projector records how long the lamp is turned on and a message and indicator notify you when it is time to replace the lamp
a. Turn on the power.
b. Press the MENU button. The Configuration menu is displayed..
c. Select Reset - Reset Lamp Hours. A reset confirmation message is displayed.
d. Use the RIGHT/LEFT buttons to select Yes and then press the ENTER to execute.
The lamp hours are reset