Sunday, June 12, 2016

Blackberry Torch 9810 – Disassembling procedure – How to remove the mother board – How to remove the camera – Mobiles and Smartphones repair and service

Category: Mobiles and Smartphones Repair and Service 

Contents of this article 

  • How to remove the case 
  • How to remove the mother board 
  • How to remove the camera module

Blackberry Torch 9810

Remove the back cover of the phone
Remove the battery
Unscrew the four screws using the T6 screw driver
If you remove the screw in red, you void the warranty!
Remove front silver trim by using plastic opening tools and wiggle it off.
This is difficult to remove, but it should come off if you do it with caution.
Once you remove the rim cover, you should find two more screws on the top. Unscrew them using the T6 screw driver.
Use the plastic removal tool to remove the entire back cover.
Unplug the black antenna wire from the logic board.
Peel off the three ribbon cables
They are orange and located on each side as well as on the top of the logic board
The cable circled in yellow is glued to the silver cap. Pull the ribbon cable upward towards the battery area.
Take out your logic board
Camera Sensor
Use the Phillip screw driver to wiggle the camera sensor out.
Carefully remove this