Monday, June 06, 2016

Logitech Webcam Pro 9000 – Disassembling procedure – How to replace the mother board – Laptop repair and service

Category: Laptop repair and Servcie 

Contents of this article 

  • How to remove the case 
  • How to remove the board
  • How to remove the power button

Logitech Webcam Pro 9000

DISASSEMBLING PROCEDURE 
Remove the two 8mm Phillips#0 screws on the back cover.
The motherboard is attaching the two covers together, so don't separate them entirely just yet.

There is a button that loosens as the Phillips screws are removed. Don't be alarmed if it falls out.
Remove the four 6mm Phillips#0 screws connecting the motherboard and front cover. DO NOT detach the wire connecting the motherboard to the front cover.
Grasp the white connector attaching the button chip wire to the motherboard.
Grab between the tabs and the socket.
Wiggle the connector back and forth to remove it from the connection box
Do not worry if you detach the red and black wire connection on the power button.
Grasp the white wire connector between the tabs and the socket.
Wiggle the connector back and forth to remove the front cover from the motherboard.
Grasp the white wire connector on the back of the motherboard to remove the USB cable.
Wiggle the connector back and forth to remove it from the socket.
Desolder the joint on the front of the motherboard to completely detach the USB cable.

Remove the two 8mm Phillips#0 screws on the back of the motherboard.
Remove the camera from the motherboard by desoldering the two connections as shown.