Saturday, June 11, 2016

Samsung Galaxy Tab 3 8.0 – Disassembling procedure – How to remove the case – How to replace the touch screen Digitizer – Tablets repair and service

Category: Tablets Repair and Service 

Contents of this article 

  • How to remove the case 
  • How to remove the battery
  • How to remove the Digitizer 

Samsung Galaxy Tab 3 8.0

TOUCH SCREEN DIGITIZER REPLACEMENT PROCEDURE 
First start out by separating the screen from the back cover by using the larger plastic opening tool to pry them apart.
After every part of the screen is separated from the back cover you should be able to fully remove it with your hands.
Now to remove the battery you must use something small, such as tweezers to disconnect the battery from its port.
Note: the connection lifts up to remove
After the battery is disconnected you may use your hands to pull out the battery. It may be a little difficult because there is adhesive on the backside of the battery to help keep it secure, but it will come out.
Disconnect the relays attached to the motherboard.
Unscrew the 2.9mm screws from the speakers using a Phillips head #000 screw driver and then lift the speakers from the device.
Take a plastic remover tool and carefully unseat each of the electric leads currently plugged into the board.
Unscrew the 2.9mm phillips #000 screw above the battery, and the 3 to the right of the
battery.
Carefully lift the board from the device.
With a plastic remover tool, gently unseat the connection of the proximity sensor to the motherboard.
Gently wedge the plastic remover tool and pry antenna loose, and lift it from the proximity sensor. The Sensor can then simply lifted from the device.
Unscrew the 2.9mm screws from the charging port with Phillips Head #000 and use the spudger to pry it up from under the port to remove component from the device.