Thursday, November 03, 2016

Alcatel mobile phone - Alcatel OneTouch Pop Icon – Disassembling procedure – Mobiles and smartphones repair and service

Category: Mobiles and smartphones Repair and Service 

Contest of this article 

  • How to remove the rear cover
  • How to remove the Mother board 
  • How to remove the Headphone Jack

Alcatel OneTouch Pop Icon

Shut down the device Flip the phone so that the screen is facing the surface you are working on
Aggressive prying may result in damaging the back panel or the internal contents of the phone.

Use the plastic opening tool to gently pry off the back panel. There is a small notch in the bottom left corner of the phone that you can use for increased leverage.
Use your thumbnail to lift the battery from the phone.

Using the J000 Phillips screwdriver, remove the twelve silver 3mm screws.
Using the J000 Phillips screwdriver, remove the one green 3mm screw.
With the screen facing you and the front facing camera to your right, insert the plastic opening tool between the screen and the interior back panel and gently pry it off.
Make sure all of the clips come undone when you pry the seam loose.
Lift the latch and gently remove the ribbon from the latch.
Use the metal spudger to gently pry the control buttons from the case.
The control buttons are glued to the case and are on a computer ribbon. When removing them it is best to move between them so as to avoid damaging them.
Make sure to use a plastic opening tool or nylon spudger before attempting to use a metal spudger. Metal spudgers can potentially damage your device.
Using tweezers, carefully detach the antenna from the motherboard.
Remove the tape on top of the ribbon.
Lift the black latch to release the ribbon.
Remove the ribbon from the latch.

Lift the tab from the casing.
Use the tweezers to remove tape the from the top of the latch. Still using the tweezers, lift the black latch to release the ribbon.
Remove the ribbon from the latch.

Remove the motherboard from the casing.
Soldering produces fumes that can be dangerous. Only solder in a well ventilated area.