Friday, January 06, 2017

HP SlateBook 10 x2 PC – Disassembling procedure – How to remove the display – How to remove the battery

 

Display enclosure
Before disassembling the tablet, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
Remove the display enclosure:
1. Lift up on the bottom edge of the display enclosure (1) until the tabs built into the enclosure release from the display assembly.
2. Remove the display enclosure (2) from the tablet.
3. Remove the display enclosure.
Reverse this procedure to install the display enclosure.
3. Remove the display enclosure.
Display panel cable
Remove the display panel cable:
1. Release the system board ZIF connector (1) to which the display panel cable is attached, and then disconnect the display panel cable from the system board.
2. Release the display panel ZIF connector (2) to which the display panel cable is attached, and then disconnect the display panel cable from the display panel.
3. Remove the display panel cable (3).
Power button board
1. Release the ZIF connector (1) to which the power button board cable is attached, and then disconnect the power button board cable from the system board.
2. Detach the power button board cable (2) from the battery. (The power button board cable is attached to the battery with double-sided tape.)
3. Detach the power button board (3) from the display assembly. (The power button board is attached to the display assembly with double-sided tape.)
4. Remove the power button board.
Volume button board
Remove the volume button board:
1. Release the ZIF connector (1) to which the volume button board cable is attached, and then disconnect the volume button board cable from the system board.
2. Detach the volume button board cable (2) from the battery. (The volume button board cable is attached to the battery with double-sided tape.)
3. Detach the volume button board (3) from the display assembly. (The volume button board is attached to the display assembly with double-sided tape.)
4. Remove the volume button board
TouchScreen cable
Remove the TouchScreen cable:
1. Release the system board ZIF connector (1) to which the TouchScreen cable is attached, and then disconnect the TouchScreen cable from the system board.
2. Release the display panel ZIF connector (2) to which the TouchScreen cable is attached, and then disconnect the TouchScreen cable from the display panel.
3. Detach the TouchScreen cable (3) from the battery. (The TouchScreen cable is attached to the battery with double-sided tape.)
4. Remove the TouchScreen cable (4).
Battery
Remove the tablet battery:
1. Remove the six Phillips PM2.0×2.5 screws (1) that secure the battery to the display assembly.
2. Release the speaker cable (2) from the clip built into the battery.
3. Remove the battery (3) from the display assembly.
Bottom cover
1. Remove the front (1) and rear rubber feet (2).
2. Remove the six Phillips PM2.0×6.35 screws (3) that secure the bottom cover to the keyboard/ top cover.
3. Remove the bottom cover (4)