Aiwa Model 1402,2002,2101
Entering
into service mode
Press [display] key
on the remote handset and button on tv set, simoultaniously. “serv”
will be displayed on screen to indicate that the tv is now in service
mode.
Service
mode keys
In service mode use following
handset keys
1
[channel^]
and [channel down] to select setting item.
2
[volume
^] and [volume down] to increase and decrease value of setting item.
3
[p--]
to store the enw value in memory.
Storage is
necessary before proceeding to the next setting otherwise the adjusted value
will be lost and previous value will remain in memory.
Aiwa
model ctv-c202
Press the hidden [test] key (hidden
under the seal, below key [8] on remote handset to activate the service mode.
1 aging
2 aft ok
3 1234H
Here aging is used to stoop the tv
set from auto shut off, when there is
no input signal, aft ok is used to display the aft [s] curve. It may show OK,
up or dn, 1234H shows the total hours (In hexadecimal) the tv set {crt} was on.
Cancellation of service mode
Service mode is released by pressing
the [test] key once again.
Replacing
EEPROM
1 press [test] key (Hidden) on the
remote control unit to activate the service mode.
2 Press [display] key on the remote
control and verify the screen.
3 Press channel up/down button on the
remote control and then move the red colour to K3.
4 Press [volume up/down] key on the
remote control to set the data as given below
Up dn s 1 2 3 k 2 3 4 Y
+ - 0 0 0 0 1 0 0
5
in
the same sequence as in step 3 and 4, move crusor to K4. Then set the data as
shown below.
Up dn S 1 2 3 K 2 3 4 Y
+ - 0 0 0 0 0 1 0
6
With conditions as they are in step 5, press
the [display] key and then press the [finish] key (hidden key, next to [system]
key)
7
Following the display of “initial” on the
screen for few seconds the power will automatically go off.
