PANASONIC DMR-ES15PL
DVD RECORDER
SERVICE MODE AND POWER SUPPLY CIRCUIT
Self-Diagnosis Functions
Self-Diagnosis Function provides information for errors to service personnel by ìSelf-Diagnosis Displayî when any error has occurred.
U**, H** and F** are stored in memory and held.
You can check latest error code by transmitting [0] [1] of Remote Controller in Service Mode. Automatic Display on FL will be cancelled when the power is turned off or AC input is turned off during self-diagnosis display is ON.
Self-Diagnosis Function provides information for errors to service personnel by ìSelf-Diagnosis Displayî when any error has occurred.
U**, H** and F** are stored in memory and held.
You can check latest error code by transmitting [0] [1] of Remote Controller in Service Mode. Automatic Display on FL will be cancelled when the power is turned off or AC input is turned off during self-diagnosis display is ON.
Service Modes
Service mode setting:
While the power is off, press REC, CH UP and OPEN / CLOSE simultaneously for
five seconds
How to replace the Lithium Battery
REPLACEMENT PROCEDURE
1. Remove the Top case, Front Panel, RAM/Digital P.C.B. Module, DV Jack, Rear Panel, Front (L) P.C.B. and Main P.C.B..
2. Unsolder the Lithium Batteries: B7501 and then replace it into new one.
REPLACEMENT PROCEDURE
1. Remove the Top case, Front Panel, RAM/Digital P.C.B. Module, DV Jack, Rear Panel, Front (L) P.C.B. and Main P.C.B..
2. Unsolder the Lithium Batteries: B7501 and then replace it into new one.
NOTE:
The lithium battery is a critical component. ( Type No.: CR2354-1GUFE Manufactured by Panasonic.)
It must never be subjected to excessive heat or discharge.
It must therefore only be fitted in equipment designed specifically for its use.
Replacement batteries must be of the same type and manufacture.
They must be fitted in the same manner and location as the original battery, with the correct polarity contacts observed.
Do not attempt to re-charge the old battery or re-use it for any other purpose.
It should be disposed of in waste products destined for burial rather than incineration.
The lithium battery is a critical component. ( Type No.: CR2354-1GUFE Manufactured by Panasonic.)
It must never be subjected to excessive heat or discharge.
It must therefore only be fitted in equipment designed specifically for its use.
Replacement batteries must be of the same type and manufacture.
They must be fitted in the same manner and location as the original battery, with the correct polarity contacts observed.
Do not attempt to re-charge the old battery or re-use it for any other purpose.
It should be disposed of in waste products destined for burial rather than incineration.
POWER SUPPLY CIRCUIT
CLICK ON THE IMAGES TO ZOOM IN
