SAMSUNG LE32A65 - LE37A65 - LE40A65 - LE46A65 - LE52A65
SERVICE MODE
Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote – control
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote – control
INFO > MENU > MUTE > Power on
- If you have Factory remote – control
PICTURE ON > DISPLAY > FACTORY
The buttons are active in the service mode.
1. Remote - Control Key : Power, Arrow Up, Arrow Down, Arrow Left Arrow Right, Menu, Enter, Number Key(0~9)
2. Function - Control Key : Power, CH +, CH -, VOL +, VOL -, Menu, TV/VIDEO(Enter).
1. Remote - Control Key : Power, Arrow Up, Arrow Down, Arrow Left Arrow Right, Menu, Enter, Number Key(0~9)
2. Function - Control Key : Power, CH +, CH -, VOL +, VOL -, Menu, TV/VIDEO(Enter).
Panel Check
You have to check Panel Maker Because of different adjustments as follows.
First of all, Check the label rating!
1) Label Rating File
- LCD PANEL MARK
A:ACER(AUO) S : SEC C : CMO
* If not printed you could consider S(sec) panel mark
You have to check Panel Maker Because of different adjustments as follows.
First of all, Check the label rating!
1) Label Rating File
- LCD PANEL MARK
A:ACER(AUO) S : SEC C : CMO
* If not printed you could consider S(sec) panel mark
Factory Data
1. Option Table(Service)
2. WB Adjust
3. Information
CheckSum
T-PRLPEUMD-**** (Main Micom Ver.)
T-PERLDEUC-**** (DTV SW Ver.)
T-PRLPEUS-**** (Sub Micom Ver.)
Month/Day/Year
Hour/Min./Sec.
4. Advanced Menu
1. Option Table(Service)
2. WB Adjust
3. Information
CheckSum
T-PRLPEUMD-**** (Main Micom Ver.)
T-PERLDEUC-**** (DTV SW Ver.)
T-PRLPEUS-**** (Sub Micom Ver.)
Month/Day/Year
Hour/Min./Sec.
4. Advanced Menu
White Ratio (Balance) Adjustment
1. You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
2. Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, Component 1 and HDMI 1 modes.
3. The optimal values for each mode are confiured by default. (Refer to Table 1, 2) It varies with Panel’s size and Specifiation..
- Equipment : CS-210
- Pattern: MIK K-7256 #92 “Flat W/B Pattern” as standard
- Use other equipment only after comparing the result with that of the Master equipment.
- Set Aging time : 60min
