SONY - KDL-32W5800 - KDL-37W5800 - KDL-40W5800 - KDL-46W5800 - KDL-52W5800
SERVICE MODE AND POWER SUPPLY CIRCUIT
To bring up the self diagnostic
screen display
In standby mode, press the following buttons on the remote commander sequentially in rapid sucession as shown below:
In standby mode, press the following buttons on the remote commander sequentially in rapid sucession as shown below:
ON SCREEN DIASPLAY > CHANNEL 5 > VOLUME –
> POWER ON
SERVICE
MODE
1. Turn on the power to the TV set and enter
into the stand-by mode.
2. Press the following sequence of buttons on the Remote Commander.
2. Press the following sequence of buttons on the Remote Commander.
ON SCREEN DIASPLAY > CHANNEL 5 > VOLUME +
> POWER ON
After carrying out the service adjustments, to
prevent the customer accessing the ‘Service Menu’ switch the TV set OFF and
then ON.
Changing
TVM Data Settings
1. Press “2 / 5” on the remote commander to
select (up / down) category
2. Press “1 / 4” on the remote commander to select (up / down) item
3. Press “3 / 6” on the remote commander to select (up / down) data
2. Press “1 / 4” on the remote commander to select (up / down) item
3. Press “3 / 6” on the remote commander to select (up / down) data
Writing TVM Data
1. Press “Mute” on the remote commander. The
word “SERVICE” changes to “WRITE”
2. Press “0” on the remote commander. The word
“WRITE” changes to red. This indicates writing is in progess.
POWER SUPPLY CIRCUIT
CLICK ON THE IMAGE TO ZOOM IN
